[. . . ] Should any abnormal function occur, reset the unit and turn it on again. tURNING THE CAMCORDER ON AND OFF Press the Power button (1) to turn the camcorder on. To store pictures or videos, you need to insert a micro SD card (not included) into your digital camcorder so you can save your files. Insert the micro SD card carefully into the micro SD card slot and push firmly until you hear a "click" sound. [. . . ] Note: when you select "Off", the image is turned upside down for easier viewing. Motion Detection When this function is activated, the camcorder starts recording automatically when it detects motion. The recording automatically stops when no motion is detected for more than 10 seconds. "Date" menu For more information about the "Date" menu, please refer to the "Date" menu section. "Setup" menu For more information about the "Setup" menu, please consult the "Setup" menu section. Turn the camcorder on and press MODE button to set the device to capture mode. Using the LCD screen (8) to frame your subject, hold the camcorder steady. notes: · In Photo mode, the number of photos that can still be stored on the memory card is displayed in the upper right corner of the screen. When the memory is full, "Card Full" will appear on the screen. Do not take the memory card or batteries out when the camcorder is saving the image, otherwise, the image will not be saved completely. The Zoom level icon on the right side of the LCD screen shows how much zoom you have selected. Press MODE button (7) until playback mode is displayed on the top left corner of the LCD screen. Press the shutter button, then select "Yes" by using Up/Down keys. Select a lower image quality to decrease image size in order to capture more images: Fine / Normal. "Date" menu For more information about the "Date" menu, please refer to the "Date" menu section. "Setup" menu For more information about the "Setup" menu, please consult the "Setup" menu section. To switch between modes, press MODE button repeatedly to select the mode you want. To switch between modes, press MODE button repeatedly to select the mode you want. Press MODE button once to go back to the previous screen or twice to go back to the main display. The following settings are available in the "Setup" menu: 1. Sound Effect Sets sound options for the following: Shutter / Start-up / Beep. Frequency A higher frequency increases the camcorder shutter speed so that the effect of light fluctuations from sources such as fluorescent lamps are reduced: 60 Hz / 50 Hz. [. . . ] If the image does not display in the center of the TV screen, adjust the TV settings (refer to the TV instruction manual). The batteries are also used when the camcorder is connected to the TV. There are two ways to connect the content of your camcorder to your computer: a. Remove the camcorder's micro SD card and put it into a card reader and insert the card reader into your computer. [. . . ]